One point of contact
Material, application and readers come from one place; you do not have to tie two suppliers together.
From needs analysis to field operation.
Every project follows the same four phases. Scope is set by the product’s structure and the risk it faces.
Process
Four phases, clear responsibilities.
The outputs of each phase are shared in writing at project kick-off.
- 01
Product and surface
We decide together which product and which surface the signature goes on. It can be the packaging, the product itself, or both.
- Reviewing your range and packaging structure
- Reviewing your printing and coating steps on site
- Defining where and by whom the product will be checked
Output: The surface and the application point
- 02
Preparing the signature
A signature is prepared for you and delivered ready for use on your line. The same signature is never used for any other brand.
- Choosing the carrier that suits the surface
- An application and reading trial on samples
- Reading again after the processes the product goes through
Output: A signature ready for your line
- 03
Applying on the line
The signature reaches the product during production. Setup is completed within your planned maintenance window; line speed and layout do not change.
- A trial run on a small batch
- Verifying the signature in place with the fixed reader
- Operators learning the device in a short training session
Output: Signed production
- 04
Reading in the field
Your team, your dealer and your auditor get a result on the spot with a reader. Every reading is recorded with the product, place and time.
- Distributing readers to teams and dealers
- Gathering readings into one report
- Following suspicious reading patterns
Output: Records and reports from the field
Throughout the project
Project management principles.
Decisions from data
The signature is first tried on a small batch; the scope is decided from the reading results.
A measurable promise
What the signature delivers on which surface and under which conditions is measured and stated plainly.
FAQ
Questions about the process
How long does the process take?
It depends on your product, its surface and your production volume. The timeline is drawn up together once your production steps have been reviewed.
Can we run a trial production?
Yes. The signature is first applied to a small batch and the reading result is verified; the scope is set from that result.
Do we have to stop production?
No. Setup is completed within your planned maintenance window; because the signature is applied inside an existing step, line speed and operator workload do not change.
Who supports us during setup?
Material, application and readers come from one place. From the line review to team training, you work with a single point of contact.
Meeting request
Let's determine the right signature for your product together.
The first meeting reviews your product, sales channels and the risks you face, and recommends a suitable method.
Request a meeting